• Cleaning /Polishing of Mold and DFTS parts for semicon /Electronics Equipment.
• Preventive maintenance of electric Motors /Compressor / Generator and
• greasy equipment and machine.
• Polishing of rusty precision tooling and die / stainless steel.
• No harmful chemical and environmental friendly , can be use inside production area.

Cleaning Procedures:

MPC- is ready for immediate use. Simply follow the following instructions for best results.

• NEVER USE ON WET SURFACES.
• Clean metal surfaces with dry cloth to remove id prior applying “MPC”
• Cut a small pie. (Depending on your needs) of MPC from the sheet
• Apply a small section of “MPC’ to the metal surfaces to be cleaned and wipe clean dry soft cloth.
• Repeat until the entire areas polished.

Note: hl PC contains protective chemicals and wax and penetrate into the pores of metal, leaving a wax coating. The polished metal surfaces refrains from being rust again for much longer period.

• NEVER wash ‘MPC’ with water and any otter solution! By doing that, it will lose al it’s chemical contents and caused it to be UNUSEABLE!

-‘MPC’ gets DARKER as it rubs on metal surfaces but discoloration doesn’t affect its effectiveness. Use till it wears prior replacement.

STORAGE:

“MPC” must always be kept a cool place for storage.

Each piece of “MPC” comes with its own poly bag and should be kept inside when not in use.

Room cure: No thawing / curing required.

Sal lifetime: 6 months from the date of manufacture.

Always keep in room temperature.

TECHNICAL CONSTITUENT:

• WAX. R45
• CLEANER AQUA AMMONIA SOLUTION 268E (CONTAINING NOT LESS THAN 12% ORMORETUAN 44% AMMONIA).
• ABRASIVE – PUMICE
• OIL MINERAL 011.
• CLOTH COTTON, 275-305 WEIGHT, UNBLEACHED, SOFT FILLED SHEETING
• SCENT REAL COCONUT OIL
• CLEAR NO DYE OR COLORING AGENTS
• DEGRADABLE AND ENVIRONMENTAL SAFE

Composition / information on Ingredients:

• SYNTHETIC WAX: 12 – 17
• ACETONE: <5%
• ETHANOL:  <5%
• PROPELLANT: 20 – 30
• SILICA POWDER: 35 – 45
• 2 .0

Physical & Chemical Data

• Appearance: Yellow Colour
• > Smell: Vanilla Smell
• Flash point: Not Applicable
• Solubility in water: Not soluble in water.
• Melting (Softening) point: Not relevant
• 3.0 Hazards Identification
• Irritative with contact on eyes.
• Harmful if swallowed.

Stability & Reactivity Information

• Stability: Stable under normal condition.
• Condition to avoid: Heat, spark, or other ignition source.
• Materials to avoid: Strong acids, alkali, oxidizing agent at high temp.
• Hazardous decomposition prod: A toxic oxide of carbon and nitrogen.
• Hazardous polymerization: Will not occur at room temperature and pressure.